Fit for RC Motor Gear Puller Universal Pinion Remover Fit for Vehicle Model Small Moto

Usage of gear puller:1. Please select the needle according to the size of the motor shaft diameter. Do not use a motor with too small needle and too large shaft diameter Fit For tooth extraction, otherwise the ejector pin will be broken. The glued gear must be to melt the glue before tooth extraction!!2. Select the tooth puller thimble you need, install the tooth puller rotating rod, and tighten the screw (Note: Fit For a table thimble, the screw should not be too tight).3. Install the gear puller rotating rod into the gear puller bracket.4. Install the gear puller traveling plate.5. Clip the motor into the gear puller traveling plate and move it until the motor shaft aligns with the gear puller ejector pin.6. Rotate the gear puller lever uniformly in a clockwise direction to pull out the motor gear.7. Gear with a maximum outer diameter of 11 mm and a tooth height of 12 mm can be extracted.Origin : Mainland ChinaPackaging quantity: 1 piece

• Convenient to carry, lightweight and compact, and it is easy to install and disassemble.Omninmo motor pinion gear professional remover is made of metal material efficient wear resistant stable and reliability, easy to use. It is a great tools Fit For rc model car truck.
• Sometimes pinion gears wear out before electric motors get broken. Before getting a pricey new motor, try to replace the pinion gears first. That's when this pinion gear puller comes in handy. A money saver.
• 5 Kinds Pins: This gear puller set includes five pins Fit For pulling pinion gears of different sizes. Pins Size: 0.8mm(0.031in) (Cylindrical),1.3mm(0.051in) (Semicircular), 1.5mm(0.059in) (Cylindrical), 1.6mm(0.062in) (Cylindrical), 2.2mm(0.086in) (Semicircular). Omninmo bearing puller can gear with a maximum outer diameter of 11mm(0.43in) and a tooth height of 12mm(0.47in) can be extracted.
• Omninmo gear puller set are suitable Fit For control model, car inner rings and other dense components install and disassemble. Designed Fit For bearings, inner rings and other dense components on your car.
• Pins Size: 0.9mm (Cylindrical), 1.75mm (Semicircular), 1.75mm (Cylindrical), 1.9mm (Cylindrical), 2.8mm (Semicircular)