2 Pack 120VAC Photocell Sensor Dusk to Dawn Sensor for Outdoor Light

JAMHER Photocell Sensor for Outdoor Lights Dusk to Dawn Sensor with Automatic Illumination Detection Circuit Ideal for controlling outdoor area lighting, lighting, rear lights, rear lights, porch lights, terraces, outdoor lights, flood lights, flood lights, entrance lights, driveways, side and lights and more. When installing the switch, do not install the photosensitive hole in the direction towards artificial or reflected light. This will cause the fixture to turn on and off at night. Initial Test: During the initial installation, it takes several minutes for the light-controlled switch to turn off, which is normal. When testing lights on during the day, cover its photosensitive holes with black tape or other opaque material, and do not cover the switch with your fingers, as enough light through the gaps of your fingers will make the light-controlled switch work. The test time is about 2 minutes. Specification: Rated voltage: 120V AC Rated frequency: 50/60Hz Rated load: 1800W Tungsten, 1100VA Ballast Power consumption: 1.5W Max. Lighting light: 10~20Lx Turn-On/30~60Lx Turn-Off Working temperature: -40℃~+70℃ Working humidity: 96%

• Rated Voltage: 120V AC;Ambient Temp: -40℃~+70℃;Load power:1800W Tungsten,1100VA Ballast;Power Consumption: 1.5W max.;Wire gauge: 16 AWG;Lighting off: 10~20Lx Turn-On/30~60Lx Turn-Off
• Automatic switch: Automatically control lighting based on environmental lighting level; The internal design has an automatic ambient light level detection circuit that can be automatically turned off during the day and turned on at night. In addition, a preset 20 to 120 second delay can avoid misoperation caused by spotlights or lightning at night
• Our photocell sensor are made of good-quality plastic, rubber and zinc alloy materials, which are sturdy and durable with a protection level of IP54 for outdoor use. The dual protection sensor lens can avoid dirt and dust, and help the switch work better in harsh environments such as rain, wind, snow, etc.
• Easy to install: Disconnect the power supply, place the threads of the switch into the knock-out hole, and tighten with rubber pads and zinc alloy locking nuts.Adjustable: This photoelectric tube sensor has a rotatable base, the base of the sensor can be adjusted to avoid interference from other light sources.
• Wide application range: suitable for automatic switching control of solar LED lights, street lights, courtyard lights, corridor lights, and other lighting fixtures (please remember that LEDs use DC power, other voltages are not applicable); can also be used as photoelectric switches for small rainproof street light controllers